"SCL" stands for "Serial Clock" and it is a signal used in digital communication protocols such as I2C (Inter-Integrated Circuit) and SMBus (System Management Bus).
In an electronic circuit, the SCL signal is used to synchronize the data transfer between two devices, typically a master device and a slave device. The SCL signal is generated by the master device and is used to indicate when the data on the SDA (Serial Data) line is valid and can be read or written by the slave device.
The SCL signal is typically a square wave with a frequency that is determined by the communication protocol being used. The frequency of the SCL signal determines the rate at which data is transmitted between the devices, and it is important to ensure that the SCL signal meets the timing requirements of the communication protocol being used.
Search Knowledge Base Articles
What is "SCL"?
Did you find this article useful?
Related Articles
-
What is "OTG"?
"OTG" stands for "On-The-Go" and it is a specification for USB (Universal Serial Bus) devices that allows them to act as either a host or a peripheral... -
What is "FEL"?
"FEL" stands for "Force Entry into Bootloader" and it is a method used to enter the bootloader mode of certain electronic devices, such as Android dev... -
What is "CSI"?
"CSI" can refer to multiple things in the context of an electronic circuit, but most commonly it stands for "Camera Serial Interface."The Camera Seria... -
What is "VCC"?
"VCC" stands for "Voltage at the Common Collector" and it is a term used in electronic circuits to refer to the power supply voltage that is applied t... -
What is "CTS"?
"CTS" stands for "Clear To Send" and it is a signal used in serial communication between two devices. In a typical serial communication setup, one dev...